A: Jack up the rear of your vehicle on solid ground ensuring the vehicle is put on to two axle stands at the rear and you chock the front wheels. Apply the handbrake, remove the lower three drive shaft bolts, at the gearbox end. Repeat this on the wheel end. Release the handbrake and rotate the road wheel through 180?. Now you are able to remove the remaining three bolts at either end of the driveshaft. The CV joint is held to the driveshaft by a large circlip, with this removed the CV joint can be tapped off of the shaft. The CV boot and flange is held in place by a pinch clamp, if you replacing the joint with one of our kits, cut through this clip to remove the boot. Pack the new boot and joint with grease and follow the previous steps in reverse

.